The Lighted Bed Kit allows you to add programmable LED's to your 3D Printer. The kit is compatible with any 3D Printer that supports programmable LEDs (often referred to as Neopixels). The SKR v1.4 and SKR v1.4 Mainboards support this functionality.
Each kit contains:
- 1x LED signal splitting circuit board
- 1x 330ohm resistor
- 1x 1000uf Capactior
- 2x 3-Pin Terminal blocks
- 2x Programmable LED strips with 2 LEDs
- 2x wire leads
- 1x JST Connector with leads
This kit comes ready to solder or is also available fully assembled.
Components color, style and shape may vary slightly photo but do not affect functionality.